Save 11,55!

BlueCast CR3A LCD

107,50 95,95

Special introduction price – Limited time only


Cr3a is one of the easiest castable resins to print and ensure excellent casting. 
Differently from other monomer based resin that requires complex and tricky treatments our BC Cr3a just requires to be washed after print and cured in to BC CURING LIQUID we supply. No hot water wash required, no boiling, no overnight curing.

Ships within 24 hours

Description

BLUECAST CR3A FOR LCD PRINTERS – 500 gr

  • Consistent casting quality as BlueCast standard
  • Ash residual 0.00%  _ proprietary TGA at 750°C / 4 hrs without contact to air, in closed vessel
  • Low cost – Negligible shrinkage
  • No primer needed
  • Monomer based resin (tested as not toxic / not carcinogenic)
  • High resolution
  • Good strength
  • Fast printing speed
  • Very low odor
  • Very low viscosity, no need to heat
  • Chromacure® will tell you when postcure is done and pattern is ready to cast 

Content

  • Bottle: 500 gr

Compatible with LCD printers (405 nm with 30 watt led or higher power)

  • Phrozen Shuffle
  • Phrozen Shuffle XL
  • Wanhao D7
  • Wanhao D8
  • Zortrax Inkspire
  • Epax X1
  • Anycubic Photon (S)
  • Prusa SL1
  • Micromake L2
  • X-Cube
  • MiniQ
  • Xayav V
  • Etc

Downloads

Additional information

Weight 650 g
Dimensions 16 × 8 × 8 cm

Reviews

There are no reviews yet.

Be the first to review “BlueCast CR3A LCD”

You may also like…